In cabinet behind driver's seat:
- Press "battery on" for 5 seconds
Sit in driver's seat
- Reverser to forward (you have to do this first, otherwise nothing works)
- Raise pantograph
- Close pantograph circuit breaker
- Turn on lights to normal
- Release parking brake (button to right of driver's seat)
- Parking brake on
- Brakes to release
- Lights dimmed
- Reverser off
- Turn on SIFA, PZB and LZB (Ctrl+NumPad Enter and Shift+NumPad enter)
- Turn on AFB - press 9 then 6 on left computer panel
- Set AFB to initial speed limit
- Move off using accelerator
- Adjust speed according to speed limits using AFB
- When LZB section begins (Ü), move AFB and throttle to maximums.
- While LZB is driving the train, you don't need to acknowledge PZB indications.
- SIFA needs to be acknowledged during LZB
- Ende light will flash
- Press PZB free (End) button
- Ende light will remain solid until LZB section finishes
- Throttle to zero
- Turn off AFB (on panel which should be displayed from when you turned it on)
- AFB to zero - if you fail to do this, the train will not power again after leaving LZB area
- Speed to less than 160km/h
- Set AFB and turn it back on - optional
- Set throttle